No Hassle | Just Help
We Match All Legitimate Prices
Order by 2PM EST
We Know Trucks & Treeps
RedHead Steering Gear | RH18501 | 1974 Jeep J20
Cores with broken shafts or cases will receive partial or no core refund.
Steering Gear Fits all 1974 Jeep J20. This gear has a large (13/16?) input shaft and 4 mounting holes cast into the house. Please note that only three of the four holes might be used to actually secure this gear to the frame. This gear is the 15:1 ratio, 3 to 3.5 turns lock to lock. If you have a 18:1 ratio gear, 4 to 4.5 turns lock to lock you will need to order an 18503. If your gear is a Manual Steering Gear then you need to order the P-7104. This gearbox allows you to retain the factory steering shaft, as well as the stock pitman arm. This is a major advantage especially those with lifted trucks with dropped pitman arms, you will not have to change your pitman arm.
- 12 Month Warranty
- Built in the USA
- Housings are machined out and replaced with needle bearings
- Shafts are flame sprayed or replaced as needed
- New control valves installed on some applications
- Worm and piston assembly are custom fit with special ordered, precise oversized ball bearings
- Sector shafts are installed on a lathe to confirm they are straight and true
- Sealing surface is polished to avoid any leaks
Please return core to: RedHead Steering Gears 4302 B ST NW AUBURN, WA 98001
- Please drain core of fluid and replace port plugs
- Use plastic bag that we sent your new gearbox in (if it’s still intact) or whatever is needed to keep box from leaking
- Re-use packing materials to ensure the box is returned to us without hassle from the courier
- Also, if possible, tape or re-tape the outside of the box to help strengthen it
If these steps aren’t properly performed, the gearbox may end up in hazmat and/or be returned to sender by courier.
- Item Requires Shipping
- 30.0 lbs.
- W13.0000” x H11.0000” x L8.0000”