Yukon Pinion Install Kit For Ford Daytona 9 Inch With Crush Sleeve Eliminator Yukon Gear & Axle

Yukon Pinion installation kits are a terrific solution for gear installation on lower mileage vehicles where the carrier bearings and races can be reused. This kit uses Timken bearings and races along with high quality seals and small parts. Yukon does extensive research for each application to make sure your kit will arrive with all the correct parts you need to install your gear set.
Details:

• Fits Ford 9 inch with Daytona pinion support
• Included are Pinion Bearings and races, pinion seal, crush sleeve eliminator , complete pinion shim kit, and marking compound with brush
• 1 Year Warranty Against Manufacturer Defects
• Sold As A Kit

Fits Vehicles:

• Ford Bronco (1966 - 1986)
• Ford E-100 1/2 Ton (1968 - 1983)
• Ford E-150 1/2 Ton (1979 - 1988)
• Ford E200 3/4 Ton (1968 - 1974)
• Ford E-250 3/4 Ton (1975 - 1980)
• Ford F-100 1/2 Ton (1957 - 1983)
• Ford F-150 1/2 Ton (1968 - 1987)
• Ford Fairlane (1957 - 1971)
• Ford Falcon (1960 - 1970)
• Ford Galaxie (1959 - 1974)
• Ford Granada (1975 - 1979)
• Ford LTD (1965 - 1979)
• Ford Maverick (1970 - 1978)
• Ford Mustang (1965 - 1973)
• Ford Ranchero (1957 - 1979)
• Ford Thunderbird (1955 - 1979)
• Ford Torino / Grand Torino (1968 - 1976)
• Lincoln Continental (1957 - 1979)
• Lincoln Mark III (1968 - 1971)
• Mercury Comet (1964 - 1977)
• Mercury Cougar (1967 - 1979)
• Mercury Grand Marquis (1975 - 1980)